Volkswagen Golf Service & Repair Manual: Assembly overview - impact bar
- Qty. 2 on each side
- 2.0 Nm
- Qty. 4 on each side
- 55 Nm
| 6 - |
Pedestrian protection |
- Not installed in all markets
- Left and right
- Insert with special pop rivet pliers -V.A.G 1753A-
- Self-adhesive
- Not installed in all model versions
- Qty. 3 with adhesive film
Note
Minor differences may be encountered in respect of bumper cover,
depending on vehicle model.
1 -
Bumper cover
Material PP/EPDM
Re ...
Volkswagen R GmbH, optional equipment, “R Line” and “R”
Special tools and workshop equipment
required
...
Other materials:
Corrosion protection for body components, add-on components and welded
components
Attachments
Wings, doors, covers and flaps must be coated completely on
the inside as well. One wet-in-wet spray pass is adequate for
this.
Before installing, add-on parts must be sealed with cav ...
Introduction
This chapter contains information on the following subjects:
→ Warning lamp and coolant temperature display
→ Coolant specification
→ Checking the coolant level and refilling coolant
Never carry out any work on the engine coolant system if you are not famili ...
Removing and installing high-level brake light, Golf
Special tools and workshop equipment
required
Plastic wedge -T10039/1-
Removing:
–
Switch off ignition and all electrical loads, and pull out
...
© 2016-2024 Copyright www.vwgolf.org
Assembly overview - bumper cover
Removing and installing bumper cover