Volkswagen Golf Service & Repair Manual: Assembly overview - three-point seat belt, estate, without belt tensioner
| 1 - | Belt guide |
- Removing and installing → Chapter
| 2 - | Belt inertia reel |
- Removing and installing → Chapter
| 3 - | Bolt |
- If removed due to an accident with seat belt fastened, renew bolt
- 40 Nm
| 4 - | Bolts |
- Qty. 2
- 8 Nm
| 5 - | Bolt for rear outer belt end fitting |
- If removed due to an accident with seat belt fastened, renew bolt
- 40 Nm
| 6 - | Rear outer belt end fitting |
- Removing and installing → Chapter
Assembly overview - three-point seat belt, 4-door model, with belt tensioner
1 -
Belt inertia reel
Removing and installing
→ Chapter
2 -
Electrical wiring harness
3 -
Bolt
...
Assembly overview - three-point seat belt, estate, with belt tensioner
1 -
Belt guide
Removing and installing
→ Chapter
2 -
Belt inertia reel
Removing and installing
→ Chapte ...
Other materials:
Assembly overview - door
Note
Only the left side is shown. The right side is similar.
After renewal of B-pillar, the specified torque for bolts
-2 and 5- as well as for
-14 and 17- changes.
1 -
Rear door
Removing and installi ...
Renewing LSU Lambda probe (6-pin)
Note
If necessary, replace attachment parts, cable ties or
marking rings to match the uniform probe to the defective probe
as specified.
The wires should not be crimped or cut as otherwise the
function of the L ...
Changing headlights over from driving on left to driving on right (gas
discharge headlights with dynamic high beam control and LED daytime running
light)
If a right-hand drive vehicle is driven in a left-hand drive
country, or vice versa, the headlights must be converted. This
is necessary in order to avoid dazzling oncoming traffic with
the asymmetric low beam headlights.
Note
...
