Never carry out any work on the engine or in the engine compartment if you are not familiar with the requisite procedures and general safety requirements, or if you only have access to incorrect operating equipment, service fluids, and unsuitable tools . The work should be carried out by a qualified workshop if you are uncertain. Please ensure that the following are checked regularly, preferably every time you fill the tank:
Windscreen washer fluid level Windscreen wiper and washer Windscreen wipers Windscreen washer
Engine oil level Engine oil Engine oil Engine compartment Engine oil_5 Oil see Engine oil_5
Engine coolant level Coolant Coolant Engine compartment Coolant_4 Engine coolant see Coolant_4
Brake fluid level Braking, stopping and parking Brakes Parking
Tyre pressure Wheels and tyres Wheels and tyres Tyres see Wheels and tyres_0
Information on changing bulbs .
Calibrating Blind Spot Monitor control unit -J1086-/-J1087-
Note
Before the actual calibration process of the control units,
the calibration unit -VAS 6350- needs to be set up as described
in the following chapter.
Special tools and workshop equipment
required
  ...
Assembly overview - air duct and air distribution in passenger compartment
Note
The illustration shows a left-hand drive vehicle.
1 -
Air duct for defroster vent
Removing and installing
→ Chapter.
2 -
Air duct f ...
Assembly overview - rear brakes
Assembly overview - rear brakes:
Note
Use the brake filling and bleeding equipment -VAS 5234- to
draw off brake fluid from the brake fluid reservoir.
Before removing a brake caliper or disconnecting ...