First read and observe the introductory information
and safety warnings
ParkPilot settings in the infotainment system menu
Switch on the ignition.
If necessary, switch on the infotainment system.
Press the
button.
Touch the function button.
Touch the Parking and manoeuvering function button.
Select the required settings in the ParkPilot menu.
Function button: action |
---|
![]() ![]() ![]() |
Front volume: different volumes can be set separately for the acoustic warnings for the front by touching the - or + function buttons, or by adjusting the control. |
Front pitch: different pitches can be set for the acoustic warnings for the front by touching the - or + function buttons, or by adjusting the control. |
Rear volume: different volumes can be set for the acoustic warnings for the rear by touching the - or + function buttons, or by adjusting the control. |
Rear pitch: different pitches can be set for the acoustic warnings for the rear by touching the - or + function buttons, or by adjusting the control. |
Audio volume reduction: setting the level to which the infotainment system volume should be reduced when the ParkPilot is active. |
Audio volume reduction
Menu option | Explanation |
---|---|
Off | The volume in the infotainment system is not reduced. |
Low | The volume in the infotainment system is reduced slightly. |
Medium | The volume in the infotainment system is reduced to medium. |
Strong | The volume in the infotainment system is reduced to a minimum. |
Muting the ParkPilot acoustic warnings
You can mute the acoustic signals from the ParkPilot by touching the
function button on the infotainment system screen.
Touch the function button again to switch the acoustic signals back on.
The mute setting will be cancelled if the ParkPilot system is switched off and on again. Error warnings cannot be switched off.
If the ParkPilot display has been switched off manually and ParkPilot remains active, the mute setting is also cancelled.
The ParkPilot is automatically muted when the electronic parking brake is switched on.
The mute setting is active if the ParkPilot was switched on using the
button with the selector lever in position
P.
Removing and installing bonnet release lever
Removing
–
Tighten release lever -1- and unlock
bonnet.
–
Insert a small screwdriver in gap between release lever
-1- and retaining clip
-2-.
–
Lever re ...
Removing and installing turn signal switch -E2-, Valeo
Note
The turn signal switch -E2-, cruise control system switch
-E45- and intermittent wiper switch -E22- are combined to form
the steering column combination switch -E595-.
These switches cannot be separated.
...
Assembly overview - Bowden cable
1 -
Release lever
Removing and installing
→ Chapter
2 -
Bolt
Qty. 2
1.5 Nm
3 -
Mounting bracket
4 -
Expanding nut
Qty. 2
5 - ...