Volkswagen Golf Service & Repair Manual: Removing and installing tensioner for poly V-belt, vehicles without air
conditioner compressor
– |
Remove poly V-belt from tensioner
→ Chapter „Removing and installing poly V-belt, vehicles without
air conditioner compressor“. |
|
|
|
– |
Remove bolts -arrows- and
detach poly V-belt tensioner -1-. |
Installation is carried out in the reverse order; note the
following: |
– |
Install poly V-belt
→ Chapter. |
→ Chapter „Assembly overview - poly V-belt drive, vehicles
without air conditioner compressor“ |
|
|
|
Special tools and workshop equipment
required
Locking pin -T10060 A-
Removing
...
Removing
–
Remove poly V-belt from tensioner
→ Chapter „Removing and installing poly V-belt, vehicles with
air condi ...
Other materials:
The roll-back function for the electric panorama sliding/tilting roof
First read and observe the introductory information
and safety warnings The roll-back function can reduce the risk of crush injuries
when closing the electric panorama sliding/tilting roof . If the electric panorama
sliding/tilting roof cannot close because it is stiff or obstructed, it w ...
Removing and installing heat shield for centre exhaust system
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
Removing
–
Removing rear exhaust system
→ Rep. gr.26.
–
Loosen lock washers -2-.
...
Tyre monitoring indicator lamp
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
The tyre pressure of one tyre or several tyres has decreased considerably
in comparison to the tyre pressure set by the ...
© 2016-2024 Copyright www.vwgolf.org