Volkswagen Golf Service & Repair Manual: Technical data

Volkswagen Golf Service & Repair Manual / 7- speed dual clutch gearbox 0CW / Technical data / Technical data

Allocation gearbox - engine

Golf 2013 ►, Golf Estate 2014 ►

Always take account of the gearbox code if spare parts are required for a repair.

Gearbox code for petrol engines
QGM	PNA, NNN, PLE, PWM, PYT, QRL, QHV, QSA	PNA, PLE, PWM, PYT, QRL, QHV, QSA, QXM, RES	MSP, PNB, PLF, PWN, PYU, QRM, QHW, QSB
1.0 l - 81, 85 kW TSI	1.2 l - 77, 81 kW TSI	1.4 l - 90, 92 kW TSI	1.4 l - 103, 110 kW TSI

Gearbox code for natural gas engines
PLE, PWM, PYT, QRL, QHV, QSA
1.4 l - 81 kW TGI

Gearbox code for diesel engines
NAR, PMZ, PLD, PWL, PYS, QHU, QRK, QRZ				PMZ
1.6 l - 77, 81 kW TDI				2.0 l - 81 kW TDI

Capacities

The 7-speed dual clutch gearbox has two separate and different oil systems. One for the gear oil section -arrow A- and one for the hydraulic fluid section -arrow B-.

Technical data

Capacities

Gear oil section

In case of repair

Capacity → Chapter „Gear oil“

Change

No change necessary

Change only after repair if the oil has been drained.

Lubricant

Gear oil for dual clutch gearbox 0CW Part number → Electronic Parts Catalogue (ETKA)

Capacities	Hydraulic oil part with mechatronic unit for dual clutch gearbox -J743-
Initial filling	1 litre
Change	No fluid change possible It is not possible to check the fluid level in the hydraulic section of the mechatronic unit for dual clutch gearbox -J743-.
Lubricant	Hydraulic fluid

Caution

Risk of damage to gearbox.

Only the gear oil for the 7-speed dual clutch gearbox 0CW, which is available through the replacement parts system, may be used → Electronic Parts Catalogue (ETKA).

Other oils will lead to malfunctions or failure of the gearbox.

It is not possible to check the fill level of the hydraulic fluid section of the mechatronic unit for dual clutch gearbox -J743-. For installation work, the breather of the mechatronic unit for dual clutch gearbox -J743- must be sealed so that no oil can escape → Anchor. If any oil escapes from the hydraulic fluid section of the mechatronic unit for dual clutch gearbox -J743-, it is not possible to replenish it or check the level!

If oil escapes from the gear oil part, it can only be rectified by changing the gear oil → Chapter. It is not possible to check the fill level.

If the level of oil/fluid is too high or too low in either of the parts, the function of the gearbox will be impaired.

Nuts and bolts

Loosen and tighten securing bolts and securing nut for covers and housings diagonally. Specified torques settings are specified for unoiled bol ...

Overview - power transmission

Overview - power transmission - front-wheel drive The 7-speed dual clutch gearbox 0CW equipped with 5 shafts. 2 input shafts and 3 output shafts. A1 -&n ...

Other materials:

Checking systems with a restrictor and reservoir and air conditioner compressor regulating valve -N280- (with externally regulated air conditioner compressor)
Note Connecting air conditioner service station → Chapter. Observe the test prerequisites → Chapter. – Raise engine speed to 2,000 rpm. ...

Pipes and hoses in refrigerant circuit
The mixture of refrigerant oil and refrigerant R134a attacks certain metals (e.g. copper) and alloys and dissolves certain hose materials. Therefore, always use genuine replacement parts. The hoses and pipes are held together with screwed join ...

Masking areas, front body
Masking areas, plenum chamber A - No sealant on threads or contact surfaces. C - No cathodic dip primer, surfacer or top coat on threads or contact surfaces. D - Threads free of surfacer and top-coat pa ...