|
Test and measurement work that can be performed using a pressure gauge
Classification of extraction and charging devices in groupsRenewing bulb for glove compartment light -W6-
Note
If an LED glove compartment light -W6- is faulty, the entire
light must be renewed.
Removing
–
Remove glove compartment light -W6-
→ Chapter.
...
Wiring open circuit with one repair position
Repair position with single crimp connector
–
Place the wire to be repaired to one side (about 20 cm
either side of the repair position).
–
If necessary, unbind the wir ...
Removing and installing tail light in rear lid
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
If the event of a defective LED, the entire tail light needs
to be rene ...