Volkswagen Golf Service & Repair Manual: Coolant pump, regulation of cooling system
- Assembly overview - coolant pump, thermostat
- Assembly overview - electric coolant pump
- Assembly overview - coolant temperature sender
- Removing and installing coolant pump
- Removing and installing toothed belt pulley for coolant pump, engine codes CHPA, CMBA, CPVA, CXSA, CZDA, CZCA, CPVB
- Removing and installing thermostat for large cooling circuit
- Removing and installing thermostat for small cooling circuit
- Removing and installing charge air cooling pump -V188-
- Removing and installing coolant temperature sender -G62
- Removing and installing coolant temperature sender at radiator outlet -G83
Checking cooling system for leaks
Special tools and workshop equipment
required
Cooling system tester -V.A.G 1274 B-
...
Assembly overview - coolant pump, thermostat
1 -
Thermostat housing
Removing and installing
→ Chapter
2 -
Thermostat
For small cooling circuit ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Locking and unlocking the driver door manually
→ Locking the front passenger door and rear doors manually
→ Unlocking the tailgate manually
→ Unlocking the selector lever lock manually
If the vehicl ...
Removing and installing lower part of sump
Special tools and workshop equipment
required
Flat scraper
Commercially available scraper
Sealant remover
Hand drill with plastic brush attachment
...
Removing and installing underbody heat shield
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
Removing
–
Removing centre underbody panel
→ Chapter.
–
Removing front tunnel cross-piec ...
