Volkswagen Golf Service & Repair Manual: Cylinder block, gearbox end

Removing and installing sealing flange on pulley end

Special tools and workshop equipment required Flat scraper Sealant → Electronic Parts Catalogue ...

Assembly overview - cylinder block, gearbox end

  Note For assembly work, secure engine to engine and gearbox support → Chapter. 1 -  Bolt Renew 60  ...

Other materials:

Removing and installing cruise control system switch -E45
  Note t  The turn signal switch -E2-, cruise control system switch -E45- and intermittent wiper switch -E22- are combined to form the steering column combination switch -E595-. ...

Removing and installing wheel bearing unit, torsion beam axle
Special tools and workshop equipment required Fitting sleeve -3241/4- Hub grease cap puller -VW 637/2- Torque wrench -V.A.G 1332- Tool insert -T10162 A- Torque wrench -V.A.G 1410-   ...

Removing and installing earth wire with battery monitor control unit -J367-, vehicles without high-voltage system
Special tools and workshop equipment required     Torque wrench -V.A.G 1331- Removing –  Removing battery -A- → Chapter. ...