Volkswagen Golf Service & Repair Manual: Mounting tyre

Volkswagen Golf Service & Repair Manual / Running gear, axles, steering / Wheels, tyres, axle align / Wheels, tyres / Mounting tyre

Ensure that the wheel rim is clean.

–	Insert new tyre valve with -VAS 6459--1-.

–	Unscrew and remove valve insert.

–	Inflate tyre to approx. 3 to 4 bar. The bead of the tyre must slip audibly over the hump of the rim.

–	Screw in valve insert.

–	Check tyre pressure to make sure prescribed pressure has been reached.

–	Balance wheel.

Mounting tyre

Removing tyre from wheel

Tyres which have been filled or sealed using tyre sealant must be drained before removal. Caution ...

Wheel change, protecting wheel centring seat against corrosion

Applies to alloy and steel wheels When changing a wheel, wheel centring seat should be waxed using wax spray to prevent corrosion between wheel centr ...

Other materials:

Assembly overview - front three-point seat belt, 4-door model and estate
1 - Bolt If removed due to an accident with seat belt fastened, renew bolt. 40 Nm 2 - Belt end fitting Removing and installing → Chapter 3 - Bolts Qty. 2 4.5 Nm ...

Assembly overview - sliding sunroof
1 - Glass panel for panorama tilting sunroof (single pane safety glass) Removing glass panel → Chapter If drive defective, remove glass panel → Chapter Adjusting glass panel → Chapter 2 - Bolt ...

Moving mechatronic unit for dual clutch gearbox -J743- into removal position by hand
Note Only if you cannot set the mechatronic unit to removal position with the vehicle diagnostic tester, you must set the unit by hand to removal position. Sometimes, the mechatronic unit cannot be removed. In this case, the gear actuator for 6th gear ...