| 1 - | Luggage compartment aerial for entry and start system -R137- |
| Removing and installing → Chapter |
| 2 - | Interface for entry and start system -J965- |
| Removing and installing → Chapter |
| 3 - | Rear bumper aerial for entry and start system -R136- |
| Removing and installing → Chapter |
Overview of fitting locations - front keyless entry system, RHD vehicles
Removing and installing interface for entry and start authorisation system
-J965-Overview of fitting locations - components inside of front passenger
compartment, LHD vehicles
1 -
Footwell vent on driver side
Removing and installing
→ Chapter
Assembly overview
→ Chapter.
2 -
Temperature flap control motor -V68-
Removing and installing
...
Raising wheel bearing assembly to unladen position (vehicles with coil
springs), rear axle
Special tools and workshop equipment required
Engine and gearbox jack -V.A.G 1383 A-
Tensioning strap -T10038-
Support -T10149-
Caution
All bolts on run ...
Introduction
This chapter contains information on the following subjects:
→ Notes on tow-starting
→ Notes on towing
→ Fitting the front towing eye
→ Fitting the rear towing eye
→ Driving notes on towing
Observe any legal requirements when towing or tow-starting.
...