Volkswagen Golf Owners Manual: Preparing the vehicle for working in the engine compartment
First read and observe the introductory information
and safety warnings
Warning lamp
First read and observe the introductory information
and safety warnings
Display
Possible cause
Solution
Bonnet not closed properly
...
Checklist
The following steps should always be carried out in the specified
order before working in the engine compartment :
Park the vehicle on a level and stable
surface.
Depress and hold t ...
Other materials:
Adjusting rear lid
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Setting gauge -3371-
Note
Vehicle must be ...
Conicity
Conicity is caused by a slight offset of the tread and/or
the belt (amounting to a few tenths of a millimetre) relative to
the geometric centre of the tyre. Taper is not visible and
cannot be measured with equipment available in the workshop.
& ...
Removing and installing auxiliary heater
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410- (4…20 Nm)
Hose clamps, up to 25 mm -3094-
...
