Volkswagen Golf Service & Repair Manual: Repair instructions

Operation and safety notes for gas discharge bulbs

  Note Never change bulbs if you are not familiar with the appropriate procedures, safety precautions or tools.   ...

Contact corrosion

Contact corrosion can occur if unsuitable fasteners (bolts, nuts, washers, etc.) are used. Therefore, only fastening elements with a special surface ...

Other materials:

Checking metering pump -V54- with end sealing valve
–  If you are uncertain as to whether the metering pump -V54--C- has an end sealing valve or not, connect e.g. hand vacuum pump -VAS 6213- to connection -A-. –  Use hand-operated vacuum pump to a generate a vacuum of ...

Filling the tank with petrol, diesel or E85
Fig. 188 Open tank flap with tank cap attached to the holder First read and observe the introductory information and safety warnings Switch off the engine, ignition, mobile telephone and auxiliary heater before filling the tank and leave them switched off during refilling. Opening the ...

Assembly overview - drive shaft, triple roller joint AAR3300i
1 -  Bolt Renew after removing Loosening and tightening → Chapter Before fitting, clean the threads in the CV joint using a thread tap. 200 Nm +180° 2 -  ...