VW Golf manuals

Volkswagen Golf Owners Manual: Using a child seat on the rear seats

First read and observe the introductory information and safety warnings 

When fitting a child seat to a rear seat, the position of the front seat must be adjusted to ensure that the child has sufficient space. Adjust the front seat according to the size of the child seat and child. Ensure that the front passenger can still maintain a correct sitting position   .

Suitable child seats

The child seat must have been approved by the manufacturer for use on the rear bench seat with side airbag.

Universal child seats in groups 0, 0+, 1, 2, or 3 as specified in ECE-R 44 can be fitted to the rear seats.

The outer seats are suitable for child seats with the ISOFIX system which are specially approved for this vehicle type by ECE-R 44.

ISOFIX child seats approved for use on rear seats

There are different categories of ISOFIX child seats: universal, semi-universal and vehicle-specific.

WARNING

Any child in a child seat on the rear bench seat may sustain fatal injuries if they play with lockable seat belts that are not in use.
Using a child seat on the front passenger seat
First read and observe the introductory information and safety warnings Not all countries allow you to transport children on the front passenger seat. Not every child seat is suitable for use on ...

Securing child seats with a seat belt
First read and observe the introductory information and safety warnings It is permissible to fasten child seats with universal written on the orange label to the seats using the seat belt, but ...

Other materials:

Operating ParkPilot
Fig. 148 ParkPilot ultrasound sensors around the vehicle, A: in the front bumper, B: in the rear bumper Fig. 149 In the lower section of the centre console: button for switching the ParkPilot on and off First read and observe the introductory information and safety warnings The ParkPilot ...

Removing and installing onboard supply control unit -J519-, LHD vehicles
  Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode → Vehicle diagnostic tester. Removing â ...

Assembly overview - starter, vehicles with dual clutch gearbox (DQ250-6F)
1 -  Starter -B- Removing and installing → Chapter 2 -  Bolt Specified torque: 40 Nm 3 -  Electrical connector 4 -  Nut Speci ...

© 2016-2024 Copyright www.vwgolf.org