VW Golf manuals

Volkswagen Golf Service & Repair Manual: Checking auxiliary air heater element -Z35- with auxiliary air heater control unit -J604-, LHD vehicles

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Front heater and air conditioning unit / Checking auxiliary air heater element -Z35- with auxiliary air heater control unit -J604-, LHD vehicles

Checking
Special tools and workshop equipment required
Vehicle diagnostic tester with current probe 100 A -VAS 5051B/7-
Test conditions
Intake temperature less than 19° C
Coolant temperature less than 80° C
Passenger compartment temperature about 20° C
Battery voltage greater than 11 V
Alternator load not greater than 50 % (terminal DF)
Engine speed greater than 450 rpm
Turn rotary knob for interior temperature to highest temperature (on vehicles with Climatronic select highest level).
Test procedure
–  Remove left centre console trim in footwell → General body repairs, interior; Rep. gr.68.
   
–  Using vehicle diagnostic tester and current probe 100 A -VAS 5051B/7-, measure current draw -arrow- on earth wire -1- of auxiliary air heater element -Z35--2-.
Low heat output ≈ 30 amps
Medium heat output ≈ 60 amps
High heat output ≈ 80 amps
 

Checking auxiliary air heater element -Z35- with auxiliary air heater control unit -J604-, LHD vehicles

Removing and installing fresh air blower - V2-, RHD vehicles
  Note If only the fresh air blower -V2- is defective, remove and install fresh air blower control unit -J126- → Chapter. ...

Checking auxiliary air heater element - Z35- with auxiliary air heater control unit - J604-, RHD vehicles
Checking Special tools and workshop equipment required Vehicle diagnostic tester with current probe 100 A -VAS 505 ...

Other materials:

Introduction
This chapter contains information on the following subjects:  → Displays    → Description  ProActive occupant protection is an assistance system that initiates action to protect vehicle occupants in dangerous situations. However, the system cannot prevent a collision. Add ...

Checking pistons and cylinder bores
Checking piston –  Using a micrometre, measure approx. 10 mm from the lower edge, perpendicular to the piston pin axis. Maximum deviation from nominal dimension: 0.04 mm   ...

Removing and installing anti-theft alarm sensor -G578-, version with 2 bolts
Removing     –  Remove front interior light -WX1- → Chapter. –  Remove bolts -2-. –  Remove roof module -1- in ...

© 2016-2024 Copyright www.vwgolf.org