VW Golf manuals

Volkswagen Golf Service & Repair Manual: Assembly overview - air duct and air distribution in passenger compartment

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Air duct / Assembly overview - air duct and air distribution in passenger compartment

  Note
The illustration shows a left-hand drive vehicle.
   

Assembly overview - air duct and air distribution in passenger compartment

1 -  Air duct for defroster vent
Removing and installing → Chapter.
2 -  Air duct for centre dash panel vent
Removing and installing → Chapter.
3 -  Footwell vent on front passenger side
Removing and installing → Chapter.
4 -  Removing and installing rear footwell vent
Removing and installing → Chapter.
5 -  Air duct for rear of centre console
Installed depending on vehicle equipment. On vehicles without air duct for rear vent in centre console a respective cover is fitted on heater unit instead.
Removing and installing → Chapter.
6 -  Air duct for rear vent in centre console
Installed depending on vehicle equipment. On vehicles without air duct for rear vent in centre console a respective cover is fitted on heater unit instead.
Removing and installing → Chapter.
7 -  Removing and installing rear footwell vent
Removing and installing → Chapter.
8 -  Footwell vent on driver side
Removing and installing → Chapter.
Air duct
...

Removing and installing fresh air intake, LHD vehicles
Removing –  Remove plenum chamber cover → General body repairs, exterior; Rep. gr.50. –  ...

Other materials:

Releasing gas and draining rear gas-filled shock absorbers, conventional shock absorbers
Clamp gas-filled shock absorber vertically in vice.   WARNING Safety goggles must be worn when drilling. –  Drill a 3 mm hole -A- through ...

Working on refrigerant circuit
Repairs requiring the opening of the refrigerant circuit must only be carried out by specially trained personnel. Notes on repairs to vehicles with air conditioning and on handling refrigerant can be found in ELSA under → Air c ...

Checking outer constant velocity joint
The joint is to be dismantled to renew the grease if it is heavily soiled, or to check the running surfaces of the balls for wear and damage. Removing     –  Before disman ...

© 2016-2024 Copyright www.vwgolf.org