Volkswagen Golf Service & Repair Manual: Front heater and air conditioning unit
- Assembly overview - heater and air conditioning unit, Climatronic
- Assembly overview - add-on parts of heater and air conditioning unit and of air intake box
- Assembly overview - evaporator housing
- Assembly overview - flaps and partitions in air distribution housing
- Removing and installing heater and air conditioning unit
- Dismantling and assembling heater and air conditioning unit
- Removing and installing air distribution housing
- Removing and installing holder for heater and air conditioning unit
- Removing and installing evaporator
- Removing and installing fresh air blower control unit -J126-, LHD vehicles
- Removing and installing fresh air blower control unit -J126-, RHD vehicles
- Removing and installing dust and pollen filter, LHD vehicles
- Removing and installing dust and pollen filter, RHD vehicles
- Removing and installing fresh air blower -V2-, LHD vehicles
- Removing and installing fresh air blower - V2-, RHD vehicles
- Checking auxiliary air heater element -Z35- with auxiliary air heater control unit -J604-, LHD vehicles
- Checking auxiliary air heater element - Z35- with auxiliary air heater control unit - J604-, RHD vehicles
- Removing and installing auxiliary air heater element -Z35- with auxiliary air heater control unit -J604-, LHD vehicles
- Removing and installing auxiliary air heater element - Z35- with auxiliary air heater control unit - J604-, RHD vehicles
- Removing and installing Valeo heat exchanger, LHD vehicles
- Removing and installing Valeo heat exchanger, RHD vehicles
- Removing and installing Denso heat exchanger, LHD vehicles
- Removing and installing Denso heat exchanger, RHD vehicles
- Removing and installing coolant pipes at heat exchanger (Valeo)
- Removing and installing coolant pipes at heat exchanger (Denso)
- Removing and installing evaporator temperature sensor -G308-, LHD vehicles
- Removing and installing evaporator temperature sensor -G308-, RHD vehicles
- Checking condensation drainage
- Removing and installing condensation drainage (LHD)
- Removing and installing condensation drain (RHD)
- Removing and installing baffle plate, LHD vehicles
- Removing and installing baffle plate, RHD vehicles
Removing and installing front air distribution flap actuation unit,
Climatronic, RHD vehicles
Removing
–
Remove dash panel central tube
→ General body repairs, interior; Rep. gr.70.
– ...
Assembly overview - heater and air conditioning unit, Climatronic
Note
There are different designs and makes of heater and air
conditioning unit. The individual components of the various
heaters and air conditio ...
Other materials:
Running-in
First read and observe the introductory information
and safety warnings Please follow the regulations concerning running-in new
parts.
Running in a new engine
Any new engine has to be run in during the first 1,500 kilometres. During its
first few hours of running, the internal friction in ...
Removing and installing front air distribution flap control motor -V426-,
RHD vehicles
Special tools and workshop equipment
required
Vehicle diagnostic tester
First carry out the following work:
–
Switch off all electrical consumers.
–
...
Assembly overview - air duct and air distribution in passenger compartment
Note
The illustration shows a left-hand drive vehicle.
1 -
Air duct for defroster vent
Removing and installing
→ Chapter.
2 -
Air duct f ...
