Note
|
|
Removing and installing wheel bearing housing
Special tools and workshop equipment required
Ball joint puller -3287A-
Spreader -3424-
Ball joint puller -T10187-
Torque wrench -V.A.G 1332-
Engine and gearbox jack -V.A.G 1383 A-
Angl ...
Removing and installing rear lid seal
In the factory a sealant is applied to the rear lid seal, the seal is fitted
to the body flange and then rolled on.
Note
When the seal is removed, the sealant on the inside of the seal will
be spread and the flanks will be bent out slightly. If the seal is then
refitted, sealing and fir ...
Overview of fitting locations – Start/Stop system
Note
Note safety precautions
→ Chapter.
The illustration shows fitting locations for LHD vehicles.
Fitting locations for RHD vehicles are similar.
1&nb ...